Cam installation ?

[BlkRam1]

What size dowels are you using to hold up the lifters? Thanks fellas:HoleShotHolset:

[Jim]

1/2" dowels, cut them about 12" long if your head is on the engine. Use a grinder or sander to slightly taper the end that will go into the tappet. Make sure your centered in the tappet before tapping in the dowel with a small hammer or equivalent.

[BlkRam1]

1/2" dowels, cut them about 12" long if your head is on the engine. Use a grinder or sander to slightly taper the end that will go into the tappet. Make sure your centered in the tappet before tapping in the dowel with a small hammer or equivalent.

Aiight thanks Jim:smilielol: see that the 12v guy comes to the rescue:HoleShotHolset:

[BlkRam1]

1/2" dowels, cut them about 12" long if your head is on the engine. Use a grinder or sander to slightly taper the end that will go into the tappet. Make sure your centered in the tappet before tapping in the dowel with a small hammer or equivalent.

Aiight thanks Jim:smilielol: see that the 12v guy comes to the rescue:HoleShotHolset: now that I think about it Warpig did mention somethin about the dowels:smilielol: .

[turbo246]

Aiight thanks Jim:smilielol: see that the 12v guy comes to the rescue:HoleShotHolset: now that I think about it Warpig did mention somethin about the dowels:smilielol: .

we are changin out CAMS now, we are gettin serious in power dept now :popcorn: