94-98 Cummins 12 Valve timing info (link)

[Jim]

http://dodgeram.info/tsb/1994/18-10-94a.htm

[DCreed]

WOW! That is a big PITA! Thanks for the link :Signal73: and I can see why people come to you to help/do that! :exactly:

[Jim]

WOW! That is a big PITA! Thanks for the link :Signal73: and I can see why people come to you to help/do that! :exactly:

nah if all goes well 30-45 min or so.

[sooter]

nah if all goes well 30-45 min or so.

+ misc 15 minutes for beer

[95ctd]

http://dodgeram.info/tsb/1994/18-10-94a.htm
there is a lot of good info on this site. I find myself on it quite often:HoleShotHolset:

[Diesel97]

Awesome link.Thanks for posting it.

[PRattenbury]

Good link. Gotta be careful to use the right lift values, the ones in the initial writeup are for the 160 pump on a 1994. Gotta use the link to the table for other pump lift values. Also, didn't the 144 ft-lb torque value get changed to 160 ft-lb? Of course cleaning the pump shaft and gear thoroughly is very important, and replacing the washer under the pump gear nut is highly recommended. Did I leave anything out, Jimbo?

[BlkRam1]

Good link. Gotta be careful to use the right lift values, the ones in the initial writeup are for the 160 pump on a 1994. Gotta use the link to the table for other pump lift values. Also, didn't the 144 ft-lb torque value get changed to 160 ft-lb? Of course cleaning the pump shaft and gear thoroughly is very important, and replacing the washer under the pump gear nut is highly recommended. Did I leave anything out, Jimbo?

Yeah isnt the new updated torque spec 160 so as to lessen the chance of slipping?

[Jim]

cummins still says 144, 160 is the unofficial internet torque spec, kinda like its okay to go to 140ftlbs on regular arp studs :stirthepot: